Logo CLIENT LOGIN | MANAGE ACCOUNT | ORDER STATUS | TRACKING | LOG OUT

Our Products

Shopping cart

Shopping cart  Shopping cart
0 Product(s) in cart
Total $0.00
» Checkout

Our services



  Facebook Houzz    
         

NOMMA Member

NADRA Member

credit cards

 

Traditional Handy Crimp Deck Toggles

Made in USA
  • Deck Toggle
  • How It Works
  • Installation Instructions
  • Mounting Hardware





Traditional Handy Crimp Deck Toggles CRIMP  316SS 
CABLE
DIA.
PART NO. "L"
LENGTH
"S"
HOLE SIZE
"K"
HOLE SPACING
1/8" 10F40412 3.625" .250" 1.500"
3/16" 10F60412 3.625" .250" 1.500"
Please click part number to order.






How It Works
Deck Toggles provide a face mount solution while allowing for angled takeoff. These fittings are attached utilizing two screws through the Deck toggle base. The mounting surfaces include wood posts or blocking, on either side of a common post by through bolting, or drilling and tapping a metal post. The articulation range of this Deck Toggle end fittings is greater than 180 degrees.

Handy Crimp Tool P/N 82TST20 Required.

The strength of the cable assembly is limited to the screw strength and attaching base material.



click here for pdf Printable Format (.pdf)
Handy Crimp Installation Guide
Cable Art Inc. accepts no liability for improper use or assembly of these products.
If you have chosen hand crimping for your project the instructions below should help you with the crimping process. Please be sure to read complete instructions before proceeding. Improper installation can result in injury! If you have any questions please call before proceeding.
Step 1 - Make sure you have all the proper equipment and parts required.
Tools required are the Handy Crimp Tool (82TST20), a cable cutter, pencil, and a sharp knife.
Step 2 - If you are using vinyl coated cable it will be necessary to strip back the coating with a sharp knife as shown below. For 1/8" cable "V" should be 1-1/2" and 1-9/16" for 3/16" cable.
Step 3 - Insert stripped cable into Handy Crimp fitting and crimp 3 times as shown below. Place 3 crimps, the first 1/8" from end of fitting and two more 1/8" apart. Make sure to rotate 180 degrees for each crimp to ensure straightness of the fitting.
Step 4 - Attach completed first fitting at point of beginning and run cable to the other end making sure to adjust all turnbuckles, etc. to 2/3 open position.
Step 5 - Attach loose Handy Crimp fitting to end position and pull cable tightly along side to measure for cut as shown below
Step 6 - Repeat steps #2 and 3 for this end fitting.
Step 7 - Be sure to check all crimps with micrometer or gauge supplied with tool. Diameter as measured below should be .185 for 1/8" wire and .265 for 3/16" wire.
click here for pdf Printable Format (.pdf)



Mounting Options

Lag Bolt  18-8SS 
PART NO. SIZE DIA. LENGTH
11HLB832 1/4" 1.000"
11HLB848 1/4" 1.500"
11HLB880 1/4" 2.500"
Please click part number to order.
Button Head Allen Screw 18-8SS 
PART NO. THREAD LENGTH
11HBS8 1/4-28 .500"
Please click part number to order.


© Copyright 2021 - CABLE ART INC.