4402 series stainless steel cable railing assemblies
Use on straight runs in wood decks and railings.
(Not recommended for stairs or severe pitches.)
These are used where there is not sufficient space between the back of one of the end posts and where the other end does have sufficient space to install a Pull-Lock™ fitting.
An Adjust-A-Body™ with hanger bolt tensioning device is supplied on one end. Mount the Adjust-A-Body™ with hanger bolt on one end, string cable through the intermediate posts and opposite end post, slide Pull-Lock™ fitting on the cable and into the post. Tension the cable using an open-end wrench to tighten the Adjust-A-Body™ with hanger bolt tensioning device then cut-off excess cable from backside of the Pull-Lock™ fitting and snap on the Stainless Steel Cap.
P/N 11TCUTKIT, Cut-Off Tool for cutting the excess cable from the Pull-Lock™ fitting.
P/N 20TLB4N, Hanger Bolt Driver for use with a 5/8" socket to make screwing the hanger bolt into the post easy. Both items can be purchased at the bottom of this page.
Click here for 4402 series Cable Assemby Instructions
Click here for our Cable Railing Assemblies How-To-Order Guide