Logo CLIENT LOGIN | MANAGE ACCOUNT | ORDER STATUS | TRACKING | LOG OUT

Our Products

Shopping cart

Shopping cart  Shopping cart
0 Product(s) in cart
Total $0.00
» Checkout

Our services



  Facebook Houzz    
         

NOMMA Member

NADRA Member

credit cards

 

Traditional Handy Crimp Threaded Termination Studs

Made in USA
  • Threaded Termination Stud
  • How It Works
  • Installation Instructions
  • End Fitting Options





Traditional Handy Crimp Threaded Termination Studs CRIMP  316SS 
CABLE
DIA.
PART NO. "T"
THREAD
"D"
BODY DIA.
"L"
LENGTH
1/8" 10T40811 1/4"-28 RH .215" 2.00"
3/16" 10T60811 1/4"-28 RH .295" 2.06"
3/16" 10T61011 5/16"-24 RH .295" 2.12"
Please click part number to order.

Click here for "A" End Fitting Options






How It Works
This Stud accepts a variety of end options to complete the non-tensioning end of a cable assembly, and can be used with any type or style of post.

Handy Crimp Tool P/N 82TST20 Required.



click here for pdf Printable Format (.pdf)
Handy Crimp Installation Guide
Cable Art Inc. accepts no liability for improper use or assembly of these products.
If you have chosen hand crimping for your project the instructions below should help you with the crimping process. Please be sure to read complete instructions before proceeding. Improper installation can result in injury! If you have any questions please call before proceeding.
Step 1 - Make sure you have all the proper equipment and parts required.
Tools required are the Handy Crimp Tool (82TST20), a cable cutter, pencil, and a sharp knife.
Step 2 - If you are using vinyl coated cable it will be necessary to strip back the coating with a sharp knife as shown below. For 1/8" cable "V" should be 1-1/2" and 1-9/16" for 3/16" cable.
Step 3 - Insert stripped cable into Handy Crimp fitting and crimp 3 times as shown below. Place 3 crimps, the first 1/8" from end of fitting and two more 1/8" apart. Make sure to rotate 180 degrees for each crimp to ensure straightness of the fitting.
Step 4 - Attach completed first fitting at point of beginning and run cable to the other end making sure to adjust all turnbuckles, etc. to 2/3 open position.
Step 5 - Attach loose Handy Crimp fitting to end position and pull cable tightly along side to measure for cut as shown below
Step 6 - Repeat steps #2 and 3 for this end fitting.
Step 7 - Be sure to check all crimps with micrometer or gauge supplied with tool. Diameter as measured below should be .185 for 1/8" wire and .265 for 3/16" wire.
click here for pdf Printable Format (.pdf)

© Copyright 2021 - CABLE ART INC.